I followed iOptrons manual, iOptron iGuiderTM. Polar alignment using iPolar worked well with iOptrons PA software. All drivers installed fine and iOptron Commander sees everything. It went pretty smoothly most systems checked out except the iGuider camera. Compatible with the SkyTracker, SkyTracker Pro. GEM45G iGuider camera outputs pure noise - posted in Mounts: Im bringing up my GEM45G tonight.Capable under poor sky visibility condition.No need to rotate the mount during alignment.IPolar is a smart electronic polarscope for everyone. No need to rotate the mount during polar align.No visible Polaris (north) or Sigma Octantis (south) necessary.Works globally, no need to set northern and southern hemisphere.Can be used with the SkyTracker and SkyTracker Pro or with iOptron mounts with (Optional) adapters for internal installation.Can be easily installed inside the RA shaft on all iOptron equatorial mounts (except SmartEQ Pro).USB Video Class driver (1.1.IOptron iPolar Upgrade for SkyGuider Pro includes the iPolar electronic polarscope with rear USB connection and a special base plate cover to replace the original cover supplied with the SkyGuider Pro. usbcore: registered new interface driver uvcvideo uvcvideo: Found UVC 1.00 device iOptron iPolar (1233:1455) usb 1-1.2.3.4: FTDI USB Serial Device converter now attached to ttyUSB0 ftdi_sio 1-1.2.3.4:1.0: FTDI USB Serial Device converter detected usbserial: USB Serial support registered for FTDI USB Serial Device usbcore: registered new interface driver ftdi_sio usbserial: USB Serial support registered for generic usbcore: registered new interface driver usbserial_generic In both cases with all drivers I have tried. I have tried several iOptron drivers and both a direct USB connection to the mount and via a serial cable connected to the hand controller. I have access to one and found that it doesn't work with INDI. Recently iOptron released a new mount: the GEM45. usb 1-1.2.3.4: New USB device strings: Mfr=1, Product=2, SerialNumber=3 iOptron GEM45 was created by Wouter van Reeven. usb 1-1.2.3.4: new full-speed USB device number 7 using xhci_hcd usb 1-1.2.3.3: Manufacturer: iOptron iPolar usb 1-1.2.3.3: New USB device strings: Mfr=2, Product=1, SerialNumber=0 usb 1-1.2.3.3: new high-speed USB device number 6 using xhci_hcd usb 1-1.2.3: New USB device strings: Mfr=0, Product=1, SerialNumber=0 usb 1-1.2.3: New USB device found, idVendor=1a40, idProduct=0101, bcdDevice= 1.00 usb 1-1.2.3: new high-speed USB device number 5 using xhci_hcd Bluetooth: RFCOMM socket layer initialized

Ioptron ipolar driver